Kyocera FAX System 10 Operation Manual page 181

Fax Settings > Default fax settings
Item
FAX Remote SW Dial
Reception Port*
ECM RX (Port1)
ECM RX (Port2)*
RX Start Speed (Port1)
RX Start Speed (Port2)*
Encrypted Reception
* This function is displayed when 2 optional FAX Kits (Dual FAX option) are installed.
TX/RX Restriction
This function allows you to send or receive originals only when communication requirements are met.
Transmission Restriction (page 8-12)
RX/Forward Rules
When you have received a fax, you can forward the received image to other faxes and computers or specify a number of
copies.
Memory Forwarding (page 5-2)
New Destination Entry(FAX)
Item
New Destination Entry(FAX)
To start fax reception by operation from the connected telephone set, use the
following operation.
Value: 00 - 99
Remote Switch Function (page 5-45)
You can make one of the 2 phone lines a receive-only line.
Value: Off, Port 1, Port 2
Reception Port Selection (page 9-XX)
Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International
Telecommunication Union) that retransmits data when an error occurs. Fax
machines that have ECM mode check for errors as they communicate, preventing
distortion of the image due to noise on the line and other conditions.
Value: On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly
longer than when [Off] is selected.
Change the RX Start Speed.
When communication conditions are bad, the fax may not be received correctly. In
that case, set a lower RX Start Speed.
Value: 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Turns on reception by encrypted communication.
Value: Off, On
If turned on, select the encryption key.
Encryption (page 5-33)
Select whether to permit direct entry of destination. When this option is set to [Prohibit],
you cannot enter the destination directly.
Value: Permit, Prohibit
8-11
Description
Description