Adjusting The Seat Depth - Invacare Storm4 X-plore User Manual

3. Undo the two Allen screws (6) at the rear on the crossmember
and remove them.
4. Undo the two Allen screws (9) at the front on the seat support
plate and remove them.
5. Loosen the four Allen screws (7) and (8) which are located at the
front and back to the sides of the seat support plate to release
tension so that the plate can be moved more easily. Do not,
however, remove these screws completely.
6. Pull or push the seat support plate (2) the required width. A
scale (3) has been fitted to the bottom part of the seat support.
Use this scale to read off the seat width in centimeters.
7. Repeat these operations on the other side of the seat.
8. Now tighten all the screws again.

5.11.2 Adjusting the seat depth

Also refer to the previous chapter entitled 5.11.1 Adjusting
seat width, page 50.
The seat depth can be adjusted in stages between 380 and
530 mm.
Tools:
•
4 mm Allen key
•
8 mm jaw spanner
•
oblique pliers
•
cable binder
Particular holes in the seat support must be used to the
screws depending on the required seat depth. It may also be
necessary to replace the seat support plate.
1. Please use the following figures and the table to determine which
holes need to be used for the required seat depth, and therefore
whether the seat support plate needs to be replaced or not.
1529686-R
Adjusting the mobility device to the user's seating posture
Holes used
Seat in front seat
depth frame order
in cm no.: 1524550
38 6 & 7
5 & 7
41
43 4 & 6
43 4 & 6
46 3 & 5
48 2 & 4
48 2 & 4
51 1 & 3
53 1 & 2
2. Adjust the seat depth as described in the following chapter:
- If the seat support plate does not need to be replaced, please
refer to chapter 5.11.3 Adjusting the seat depth without replacing
the seat support plate, page 52.
- If the seat support plate does need to be replaced, please refer
Holes used Seat
in rear seat support
frame order plate
no.: 1524555 required
A & B SHORT
order no.
A & C
1526437
A & C
A & C MEDIUM
order no.
A & C
1526438
A & C
A & C LONG
order no.
A & C
1526439
B & C
51