Replacing The Heat Sink; Preliminary Steps; Removing The Defective Heat Sink - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

Ê Select "Save Changes and Exit" or "Save Changes and Reset" on
the Save & Exit menu.
Ê Confirm that the Global Error LED is off.
This is only information regarding to the change of the CPU
configuration. There is no technical problem.
"Updating or recovering the system board BIOS and iRMC" on page 71
Ê
"Enabling SVOM boot watchdog functionality" on page 78
Ê
"Switching on the server" on page 57
Ê
"Resuming BitLocker functionality" on page 84
Ê
11.3

Replacing the heat sink

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver

11.3.1 Preliminary steps

"Locating the defective server" on page 43
Ê
"Shutting down the server" on page 45
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
"Removing a riser module" on page 58
Ê

11.3.2 Removing the defective heat sink

Ê Remove the heat sink as described in section
page 215.
Ê Remove the residual thermal paste from the processor surface.
Ê Clean the processor surface using a lint-free cloth.
RX1330 M1
Upgrade and Maintenance Manual
Hardware: 15 minutes
"Removing the heat sink" on
Processor
221