System board and components
iRMC microSD card
●
The iRMC microSD card is necessary for using the embedded Lifecycle
Management (eLCM) functionality of the iRMC.
14.2
CMOS battery
14.2.1 Replacing the CMOS battery
Upgrade and Repair Unit
(URU)
Tools: tool-less; recommended: tooth pick
Safety notes
V
CAUTION!
The CMOS battery must be replaced with an identical battery or with
●
a battery type recommended by the manufacturer.
Keep lithium batteries away from children.
●
Do not throw batteries into the trash can. Lithium batteries must be
●
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section "Environmental
●
protection" in the operating manual of your server.
Ensure to insert the CMOS battery with the positive pole facing
●
up!
14.2.1.1 Preliminary steps
"Locating the defective server" on page 43
Ê
"Shutting down the server" on page 45
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
252
Upgrade and Maintenance Manual
Hardware: 5 minutes
RX1330 M1