Concluding Steps; Replacing The Irmc Microsd Card; Preliminary Steps - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

System board and components
Destroying the defective iRMC microSD card
V
CAUTION!
The iRMC microSD card contains customer information. After replacing
the iRMC microSD card, hand the defective card over to the customer. If
the customer requests disposal of the defective iRMC microSD card,
proceed as follows:
Ê Using a pair of side-cutting pliers, cut the iRMC microSD card in half.

14.5.2.3 Concluding steps

Ê Install the riser module 1 as described in section
on page 60.
"Reassembling" on page 52
Ê
"Connecting the server to the mains" on page 55
Ê
"Switching on the server" on page 57
Ê

14.5.3 Replacing the iRMC microSD card

Upgrade and Repair Unit
(URU)
Tools: a pair of side-cutting pliers

14.5.3.1 Preliminary steps

"Locating the defective server" on page 43
Ê
"Shutting down the server" on page 45
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
Ê Remove the riser module 1 as described in section
module" on page
274
58.
Upgrade and Maintenance Manual
"Installing a riser module"
Hardware: 5 minutes
"Removing a riser
RX1330 M1