Table of Contents
Advertisement
Video Operations
Switching the Video
You can switch the output of video input into the V-800HD MK II.
About the Operation Mode for Video
Transitions
Two operation modes are available for video transitions made using
the video fader: the "PGM/PST mode" and the "A/B mode. "
By factory default, the operation mode is set to the PGM/PST mode.
PGM/PST Mode
The video at the PGM position is always output, and for PST/EFFECT
position, these select the preset video (the video to be output next).
When the video fader or a button is operated, the video selected using
the PST/EFFECT section becomes the final output.
A/B Mode
When the video fader is operated, the video at the side toward which
the video fader is flipped always becomes the final output.
Setting the Operation Mode
1.
Select the [MENU] button g "System" g "Panel Operation"
2.
Use the [VALUE] knob to select "PGM-PST" or "A/B" and set
the operation mode.
3.
Press the [MENU] button to quit the menu.
22
Switching Using the PGM/PST Mode
The video in the PGM section always becomes the final output. You
use the PST/EFFECT section to select and check the preset video (the
video to output next), then switch it.
1.
Move the video fader all the way to one end or the other.
2.
Press one of the WIPE PATTERN [1] through [7] buttons or
the [MIX] button to select the transition effect.
The selected button lights up.
WIPE PATTERN [1]–[7] buttons
In this transition, the original video is broken into by the
next video.
* You can change the wipe pattern and wipe direction.
Select the [MENU] button g "Transition" g choose one
of the selections from "Wipe Patter 1" through "Wipe
Patter 7" g make settings for "Pattern" and "Direction. "
[MIX] button
The two pictures are blended together as the video is
switched.
3.
Press a cross-point button in the PST/EFFECT section to
select the preset video (the video to output next).
Lighted in red: Final output video
Lighted in green: Preset video
The preset video appears in the PVW section of the multi-view monitor.
MEMO
5 Channel 9 is used for still-image output. Channel 10 is used when
outputting a still image or monochrome picture (background
color) (p. 16).
5 You can freely assign channels of your choosing to cross-point
buttons. For details, refer to "Changing Cross-point Assignments"
(p. 33).
(the video to be output next)
Hide quick links:
Advertisement
Table of Contents
