Ricoh PENTAX K-3 II Operating Manual page 113

servicing fees may be charged by the manufacturer's
representatives in that country. Notwithstanding this, your
camera returned to the manufacturer will be serviced free
of charge according to this procedure and warranty policy.
In any case, however, shipping charges and customs clearance
fees to be borne by the sender. To prove the date of your
purchase when required, please keep the receipt or bills
covering the purchase of your camera for at least a year.
Before sending your camera for servicing, please make sure
that you are sending it to the manufacturer's authorized
representatives or their approved repair shops, unless you are
sending it directly to the manufacturer. Always obtain
a quotation for the service charge, and only after you accept
the quoted service charge, instruct the service station
to proceed with the servicing.
• This warranty policy does not affect the customer's statutory
rights.
• The local warranty policies available from our distributors
in some countries can supersede this warranty policy.
Therefore, we recommend that you review the warranty card
supplied with your product at the time of purchase, or
contact our distributor in your country for more information
and to receive a copy of the warranty policy.
For customers in USA
STATEMENT OF FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not approved by the party responsible
for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for
help.
6
111