7 7
Finishing
A. Finishing Material
5HIHU WR 6HFWLRQ IRU FRPEXVWLEOHQRQFRPEXVWLEOH PDWH-
ULDOV 5HIHU WR )LJXUH IRU QRQFRPEXVWLEOH ]RQH
WARNING! Risk of Fire!
•
Use only non-combustible framing material below
VWDQGR V
•
Sheetrock, wood or other combustibles must NOT be
used as sheathing or facing in the noncombustible zone.
•
DO NOT FRYHU PHWDO ¿UHSODFH IURQW ZLWK FRPEXVWLEOH
materials.
,QVWDOO FRPEXVWLEOH PDWHULDOV RQO\ WR VSHFL¿HG FOHDUDQFHV
on top front and side edges.
Finished combustible wall
Combustible material
Non-combustible
decorative facing
Continuous,
non-combustible sealant
Tile, stone or other
non-combustible material
HX4 Hearth
Ext
or equivilent
insulation
Figure 7.2
Decorative Facing
You must maintain clearances.
Metal strips are placed 2 in. (51 mm)
under the front of the fireplace and must
extend beyond the front and sides of
fireplace opening by 2 in. (51 mm)
Heatilator • I60/I80 • 4013-260 Installers Manual • Rev W • 03/23
These metal surfaces
may be covered
with non-combustible
material.
Figure 7.1
Noncombustible Facing
Flat 2 x 4 stud wall
2 x 4 header, flush with
front of stand-offs
Non-combustible material
1RWH
If Lintel Bar is used make sure
LW GRHV QRW FRYHU FRPEXVWLEOH
material.
Hearth
Refractory
Floor constructed of wood or
other combustible material
Non-combustible
sealant around edge
of fireplace and drywall.