Changing The Cd-Rom, Dvd-Rom, Or Floppy Drive And Hdd Trays - Supero SC846TQ-900B User Manual

4-10 Changing the CD-ROM, DVD-ROM, or Floppy Drive
and HDD trays
The SC748 chassis supports the following drive configuration options:
Options
Option One
Option Two
Option Three
Option Four
A
After selecting one of the drive configuration options listed above, use the following
instructions to install the drives and their trays into the chassis.
Changing Drive Trays
1. Power down and unplug the system from the outlet.
2. Remove the chassis cover.
3. Disconnect the power and data cables from the drive to other chassis compo-
nents including the motherboard and backplane.
Position A
Floppy, DVD or
CD-ROM drive
Not available
Floppy, DVD or
CD-ROM drive
Open for later use
if no drive is in
position B
C
B
Figure 4-21: Drive Location Options
4-19
Chapter 4 Chassis Setup and Maintenance
Position B
Not available
3.5" fixed hard
drive
Not available
Open for later use
if no drive is in
position A
Position C
One 3.5" fixed
hard drive or two
2.5" fixed hard
drives
3.5" fixed hard
drive
Open for later use
3.5" fixed hard
drive