Table of Contents
Advertisement
5-5
DVD and Floppy Drive Installation
Most SC815 chassis models include a DVD-ROM and space for an optional floppy
drive. The DVD-ROM is usually pre-installed.
Installing or Replacing a DVD-ROM or Floppy Drive
1.
Power down the system and if necessary, remove the server from the rack
and the front bezel from the chassis.
2.
Remove the chassis cover.
3.
Unplug the drives power and data cables from the motherboard and/or back-
plane.
4.
If you are adding a new drive: Remove the mini-bezel (grate) from the drive
bay The bezel can be removed by pulling out the hard drive beneath the
DVD-ROM or floppy drive bay, then pulling the mini-bezel forward.
If you are replacing a drive: Locate the locking tab at the rear (left hand side
when viewed from the front) of the DVD-ROM or floppy drive. Push the tab
toward the drive and push the drive unit out the front of the chassis.
5.
Insert the new drive unit in the slot until the tab locks in place.
6.
Reconnect the data and power cables.
7.
Replace the chassis cover (replace the server in the rack, if necessary) and
power up the system.
Chapter 5: Chassis Setup and Maintenance
5-7
Advertisement
Table of Contents
