Table of Contents
Advertisement
5-5
DVD-ROM Drive Installation
The SC113 chassis models include a DVD-ROM, which is usually pre-installed.
Installing or Replacing a DVD-ROM Drive
1.
Power down the system and if necessary, remove the server from the rack
and the front bezel from the chassis.
2.
Remove the chassis cover.
3.
Unplug the drives power and data cables from the motherboard and/or back-
plane.
4.
Unlock the mini-bezel lock scew and remove the mini-bezel (grate) from the
drive bay The bezel can be removed by pulling out the hard drive beneath the
DVD-ROM, then pulling the mini-bezel forward.
5.
When installing or removing a DVD-ROM drive, the mini bezel lock screw
must be removed and the drive tray must be completely seperated from the
chassis.
6.
Remove the DVD-ROM from the drive tray by removing the drive screws,
then secure the replacement DVD-ROM into the drive tray, using the drive
screws.
7.
Reattach the drive tray to the chassis by replacing the mini-bezel lock screw,
and tightening it from inside the chassis.
Drive
Screws
Figure 5-4: Installing the DVD-ROM Drive
Chapter 5 Chassis Setup and Maintenance
5-5
Drive
Screw
Mini-Bezel
Lock Screw
Advertisement
Table of Contents
