Table of Contents
Advertisement
5-5
DVD-ROM Drive Installation
The SC113 chassis models include a DVD-ROM, which is usually pre-installed.
Installing or Replacing a DVD-ROM Drive
1.
Power down the system and if necessary, remove the server from the rack
and pull the mini-bezel (grate) from the DVD-ROM drive bay.
2.
Remove the chassis cover.
3.
Unplug the drives power and data cables from the motherboard and/or back-
plane.
4.
Unlock the mini-bezel lock scew and remove the mini-bezel from the drive
bay. The bezel can be removed by pulling out the hard drive beneath the
DVD-ROM, then pulling the mini-bezel forward.
5.
When installing or removing a DVD-ROM drive, the mini-bezel lock screw
must be removed and the drive tray must be completely seperated from the
chassis.
6.
Remove the DVD-ROM from the drive tray by removing the drive screws,
then secure the replacement DVD-ROM into the drive tray, using the drive
screws.
7.
Reattach the drive tray to the chassis by replacing the mini-bezel lock screw,
and tightening it from inside the chassis.
Drive
Screws
Figure 5-4: Installing the DVD-ROM Drive
Chapter 5 Chassis Setup and Maintenance
5-5
Drive
Screw
Mini-Bezel
Lock Screw
Advertisement
Table of Contents
