Oil Strainers; Inspection - Suzuki RM-Z250 Owner's Service Manual

2-14 PERIODIC MAINTENANCE

OIL STRAINERS

OIL STRAINER (Feed pump side) REMOVAL
• Drain engine oil. (!2-12)
• Remove the engine oil strainer cap.
Do not lie the motorcycle to prevent dirty engine oil
into the oil circuit when removing the oil strainer
(Feed pump side).
• Pull out the oil strainer.
NOTE:
We recommend that inspect feed pump side oil strainer every
race.
OIL STRAINER (Scavenge pump side)
REMOVAL
(!10-4)

INSPECTION

• Check the oil strainers for any damage or clogging.
• If the oil strainers are clogged, clean the oil strainers with a
compressed air.
OIL STRAINER (Scavenge pump side)
INSTALLATION
(!10-15)
OIL STRAINER (Feed pump side)
INSTALLATION
• Install the oil strainer and then tighten the oil strainer cap to
the specified torque.
Replace the gasket washer with a new one.
$ Engine oil strainer cap: 21 N·m (2.1 kgf-m, 15.0 lb-ft)
• Add new engine oil and check the oil level. (!2-11)
CAUTION
CAUTION