Fcc Part 15 - AT&T E5901, E5902B, E5903B, E5911, E5912B, E5913B, E5914B, E5921, E5922B, E5923B, E5924B, E6001, E6002B, E6012B, E6013B, E6014B, E381 User Manual

Appendix

FCC Part 15

This equipment has been tested and found to comply with the
requirements for a Class B digital device under Part 15 of the
Federal Communications Commission (FCC) rules. These require-
ments are intended to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications to this equipment not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
To ensure safety of users, the FCC has established criteria for the
amount of radio frequency energy that can be safely absorbed
by a user or bystander according to the intended usage of the
product. This product has been tested and found to comply with
the FCC criteria. The handset may be safely held against the ear
of the user. The telephone base shall be installed and used such
that parts of the user's body other than the hands are maintained
at a distance of approximately 20 cm (8 inches) or more. If you
choose to use a clipping device, please make sure to only use the
supplied AT&T belt clip.
57