Show Running-Config; Show Sysinfo; Snmp-Server; Management Vlan Commands - Planet Networking & Communication WGS3-24000 User Manual

Note Message log information is not retained across a switch reset.
:

8.1.9 show running-config

This command is used to display the current setting of different protocol packages supported on switch. This command displays
only those parameters, the values of which differ from default value. The output is displayed in the script format, which can be
used to configure another switch with same configuration.
▫
Format show running-config
▫
ModePrivileged EXEC

8.1.10 show sysinfo

This command displays switch information.
▫
Format show sysinfo
▫
Mode Privileged EXEC
▫ Switch Description - Text used to identify this switch.
▫ System Name - Name used to identify the switch.
▫ System Location - Text used to identify the location of the switch. May be up to 31 alpha-numeric characters. The factory
default is blank.
▫ System Contact - Text used to identify a contact person for this switch. May be up to 31 alphanumeric characters. The
factory default is blank.
▫ System ObjectID - The base object ID for the switch's enterprise MIB.
▫ System Up Time - The time in days, hours and minutes since the last switch reboot.
▫ MIBs Supported - A list of MIBs supported by this agent.

8.1.11 snmp-server

This command sets the name and the physical location of the switch, and the organization responsible for the network.The
range for name, location and contact is from 1 to 31 alphanumeric characters.
▫ None
Default
▫
Format snmp-server {sysname <name> | location <loc> | contact <con>}
▫
Mode Global Config

8.2 Management VLAN Commands

8.2.1 network mgmt_vlan

This command configures the Management VLAN ID.
▫ 1
Default
▫
Format network mgmt_vlan <1-4094>
▫
Mode Privileged EXEC
331