Ip Vrrp Authentication - Planet Networking & Communication WGS3-2820 User Manual

▫
Format ip vrrp <vrid> ip <ipaddr> [secondary]
▫
Mode Interface Config
12.5.4.1 no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value from the interface. To delete the primary IP
address, you must delete the virtual router on the interface.
▫
Format no ip vrrp <vrid> <ipaddress> secondary
▫
Mode Interface Config

12.5.5 ip vrrp authentication

This command sets the authorization details value for the virtual router configured on a specified interface. The parameter {none
| simple} specifies the authorization type for virtual router configured on the specified interface. The parameter [key] is optional,
it is only required when authorization type is simple text password. The parameter <vrid> is the virtual router ID which has an
integer value ranges from 1 to 255.
▫
Default no authorization
▫
Format ip vrrp <vrid> authentication {none | simple <key>}
▫
Mode Interface Config
12.5.5.1 no ip vrrp authentication
This command sets the default authorization details value for the virtual router configured on a specified interface.
▫
Format no ip vrrp <vrid> authentication
▫
Mode Interface Config
12.5.6 ip vrrp preempt
This command sets the preemption mode value for the virtual router configured on a specified interface. The parameter <vrid>
is the virtual router ID, which is an integer from 1 to 255
▫
Default enabled
▫
Format ip vrrp <vrid> preempt
▫
Mode Interface Config
12.5.6.1 no ip vrrp preempt
This command sets the default preemption mode value for the virtual router configured on a specified interface.
▫
Format no ip vrrp <vrid> preempt
▫
Mode Interface Config
User's Manual of WGS3-2820/WGS3-5220
447