Ip Http Secure-Server - Planet Networking & Communication WGS3-2820 User Manual

10.3.3 ip http secure-server

This command is used to enable the secure socket layer for secure HTTP.
▫
Default Disabled
▫
Format ip http secure-server
▫
Mode Privileged EXEC
10.3.3.1 no ip http secure-server
This command is used to disable the secure socket layer for secure HTTP.
▫
Format ip http secure-server
▫
Mode Privileged EXEC
10.3.4 ip http server
This command enables access to the switch through the Web interface. When access is enabled, the user can login to the
switch from the Web interface. When access is disabled, the user cannot login to the switch's Web server.
Disabling the Web interface takes effect immediately. All interfaces are effected.
▫
Default enabled
▫
Format ip http server
▫
Mode Privileged EXEC
10.3.4.1 no ip http server
This command disables access to the switch through the Web interface. When access is disabled, the user cannot login to the
switch's Web server.
▫
Default enabled
▫
Format no ip http server
▫
Mode Privileged EXEC
10.3.5 show ip http
This command displays the http settings for the switch.
▫
Format show ip http
▫
Mode Privileged EXEC
▫ Secure-Server Administrative Mode - This field indicates whether the administrative mode of secure HTTP is enabled
or disabled.
▫ Secure Protocol Level - The protocol level may have the values of SSL3, TSL1, or both SSL3 and TSL1.
▫ Secure Port - This field specifies the port configured for SSLT.
▫ HTTP Mode - This field indicates whether the HTTP mode is enabled or disabled.
10.4 MAC Lock Commands
10.4.1 mac-lock
This command adds the specified MAC address with <vlanid> to a specified interface. The <macaddr> parameter must be
User's Manual of WGS3-2820/WGS3-5220
417