Area Default-Cost (Ospf) - Planet Networking & Communication WGS3-2820 User Manual

according to RFC 2328, OSPF 1583 compatibility mode should be disabled.
▫
Default enabled
▫
Format 1583compatibility
▫
Mode Router OSPF Config
no 1583compatibility
This command disables OSPF 1583 compatibility.
▫
Format no 1583compatibility
▫
Mode Router OSPF Config

12.7.5 area default-cost (OSPF)

This command configures the default cost for the stub area. You must specify the area ID and an integer value between
1-16777215.
▫
Format area <areaid> default-cost <1-16777215>
▫
Mode Router OSPF Config
12.7.6 area nssa (OSPF)
This command configures the specified areaid to function as an NSSA.
▫
Format area <areaid> nssa
▫
Mode Router OSPF Config
no area nssa
This command disables nssa from the specified area id.
▫
Format no area <areaid> nssa
▫
Mode Router OSPF Config
12.7.7 area nssa default-info-originate (OSPF)
This command configures the metric value and type for the default route advertised into the NSSA. The optional metric
parameter specifies the metric of the default route and is to be in a range of 1-16777214. If no metric is specified, the default
value is ****. The metric type can be comparable (nssa-external 1) or non-comparable (nssa-external 2).
▫
Format area <areaid> nssa default-info-originate [<metric>] [{comparable | non-comparable}]
▫
Mode Router OSPF Config
no area nssa default-info-originate (OSPF)
This command disables the default route advertised into the NSSA.
User's Manual of WGS3-2820/WGS3-5220
454