Show Ip Interface Brief - Planet Networking & Communication WGS3-2820 User Manual

Routing Configuration
Interface Configuration
Status
Forward Net Directed
Broadcasts
Proxy ARP
Local Proxy ARP
Active State
Link Speed Data Rate
MAC Address
Encapsulation Type
IP MTU
Example: show ip interface
(Routing) # show ip interface 0/2
Routing Configuration.............................. Enable
Interface Configuration Status................. Enable
Forward Net Directed Broadcasts............ Disable
Proxy ARP...................................... ........Enable
Local Proxy ARP................................ .....Disable
Active State.............................................. Active
Link Speed Data Rate............................. 100 Full
MAC Address........................................... 00:10:4B:D2:17:83
Encapsulation Type................................. Ethernet
IP MTU.................................................... 1500

12.2.22 show ip interface brief

This command displays summary information about IP configuration settings for all ports in the router.
▫
Format show ip interface brief
▫
Modes Privileged EXEC
User EXEC
enable or disable. This value was configured into the unit.
Displays whether Routing Configuration is enabled or disabled on the system.
Displays whether the Interface Configuration is enabled or disabled on the system.
Displays whether forwarding of network-directed broadcasts is enabled or disabled.
This value was configured into the unit.
Displays whether Proxy ARP is enabled or disabled on the system.
Displays whether Local Proxy ARP is enabled or disabled on the interface.
Displays whether the interface is active or inactive. An interface is considered active if its
link is up and it is in forwarding state.
Is an integer representing the physical link data rate of the specified interface. This is
measured in Megabits per second (Mbps).
Is the burned in physical address of the specified interface. The format is 6 two-digit
hexadecimal numbers that are separated by colons
Is the encapsulation type for the specified interface.
The types are: Ethernet or SNAP.
Displays the maximum transmission unit (MTU) size of a frame, in bytes.
439
User's Manual of WGS3-2820/WGS3-5220