Set Gmrp Interfacemode All; Set Gvrp Adminmode; Set Gvrp Interfacemode - Planet Networking & Communication WGS3-2820 User Manual

8.6.30 set gmrp interfacemode all

This command enables GARP Multicast Registration Protocol on all interfaces. If an interface which has GARP enabled is
enabled for routing or is enlisted as a member of a port-channel (LAG), GARP functionality will be disabled on that interface.
GARP functionality will subsequently be re-enabled if routing is disabled and portchannel (LAG) membership is removed from
an interface that has GARP enabled.
▫ Disabled
Default
▫
Format set gmrp interfacemode all
▫
Mode Global Config
8.6.30.1 no set gmrp interfacemode all
This command disables GARP Multicast Registration Protocol on a selected interface.
▫
Format no set gmrp interfacemode all
▫
Mode Global Config

8.6.31 set gvrp adminmode

This command enables GVRP.
▫ Disabled
Default
▫
Format set gvrp adminmode
▫
Mode Privileged EXEC
8.6.31.1 no set gvrp adminmode
This command disables GVRP.
▫
Format no set gvrp adminmode
▫
Mode Privileged EXEC

8.6.32 set gvrp interfacemode

This command enables GVRP (GARP VLAN Registration Protocol) for a specific port.
▫
Default Disabled
▫
Format set gvrp interfacemode
▫
Mode Interface Config
8.6.32.1 no set gvrp interfacemode
This command disables GVRP (GARP VLAN Registration Protocol) for a specific port. If GVRP is disabled, Join Time, Leave
Time and Leave All Time have no effect.
▫
Format no set gvrp interfacemode
▫
ModeInterface Config
User's Manual of WGS3-2820/WGS3-5220
357