Operating Limits; Power Output; Input Voltage - Xantrex 807-1055 Owner's Manual

Freedom HFS IC Owners Guide.book Page 23 Friday, September 11, 2015 2:54 PM

Operating Limits

Power Output

The Freedom HFS can deliver up to 1000 watts or 2000 watts of
continuous utility grade sine wave AC power. The wattage rating
applies to resistive loads such as incandescent lights.
975-0727-01-01
Operating During Transition Between Shore Power and Inverter Mode

Input Voltage

The allowable Freedom HFS input battery voltage ranges are shown
in the following table:
Operating Battery Voltage
Condition Range
Full Low:10.5–16.5 volts
Operating Mid:11.8–16.5 volts
Range High:12.1–16.5 volts
Optimum 12.1–13.0 volts
Performance
Low Voltage Low: <11.0 volts
Alarm Mid: <12.3 volts
High:<12.6 volts
Low Voltage Low: <10.5 volts
Shutdown Mid: <11.8 volts
High:<12.1 volts
Instant Low <10.2 volts
Voltage
Shutdown
High Voltage 16.7 volts
Shutdown
Comment
Low refers to low limit of the low voltage threshold.
Mid refers to middle limit of the low voltage threshold.
High refers to high limit of the low voltage threshold.
A silent low battery warning shows fault code  on
the display.
A single one-second low battery alarm beeps and the
display shows fault code . After five minutes, the
unit shuts down completely.
After two seconds below the limit, the unit shuts down
and the low battery alarm sounds a long beep
continuously for 30 seconds.
The over-voltage alarm beeps every second and the
display shows fault code  alternating with the
battery voltage. The status LED turns red and the
display screen is turned OFF within 30 seconds to
protect itself from excessive input voltage.
NOTE: Although the Freedom HFS incorporates over-
voltage protection, it can still be damaged if input
voltage exceeds 16.7 volts.
23