Xantrex 807-1055 Owner's Manual page 29

Freedom HFS IC Owners Guide.book Page 15 Friday, September 11, 2015 2:54 PM
To adjust the custom battery voltage setting:
NOTE: This setting is possible only when the Battery Type setting
is set to . See "To adjust the battery type setting:" on page 14.
There are two voltage settings (Absorption and Float stages) for this
Battery Type. By default, the voltage setting of both is set to
13.6 volts (".").
1. Press and hold the Inverter Power button for five seconds.
2. Press the Inverter Power button until the LED screen flashes,
for example, "" intermittently.
3. Press and hold the Select button for five seconds to enter the
custom absorption voltage setting screen. The LED screen
flashes "".
4. Press the Select button once. The LED screen displays the
current absorption voltage. For example, ".".
5. Press the Select button to cycle through the available range of
values (12.0 to 17.0 in 0.2 increments) until you reach the
desired setting.
6. Press and hold the Select button for five seconds to make the
Absorption setting permanent.
Then, the LED screen flashes "".
7. Press the Select button once. The LED screen displays the
current float voltage setting. For example, ".".
975-0727-01-01
Freedom Inverter/Charger Configuration
8. Press the Select button to cycle through the available range of
values (12.0 to 17.0 in 0.2 increments) until you reach the
desired setting.
9. Press and hold the Select button for five seconds to make the
Float setting permanent.
To return all feature settings to factory default settings:
1. Press and hold the Inverter Power button for five seconds.
2. Press the Inverter Power button until the LED screen flashes
"" intermittently.
3. Press and hold the Select button for five seconds to return all
feature settings to their factory default settings.
15