Xantrex 807-1055 Owner's Manual page 27

Freedom HFS IC Owners Guide.book Page 13 Friday, September 11, 2015 2:54 PM
NOTE: Inverter mode ON ("") will put the inverter on standby with
the power save feature. Inverter mode ON ("") will put the inverter
on standby but without the power save feature. Both inverter modes mean
that when shore power is present, AC shore power will pass through as
AC output. And when shore power is not available, the inverter will take
power from the battery and provide AC output power. The inverter is in
operation. When the inverter mode is ON, you can manually turn inverter
operation ON or OFF by using the Inverter Power button.
For information on the Power Save feature, see "Power Save Feature" on
page 19.
Inverter mode OFF ("") completely disables inverter operation.
When in this mode, it means that when AC shore power is present, shore
power will still pass through as AC output. However, when shore power
is not available, inverter operation remains disabled and therefore the unit
does not provide AC output power. When the inverter mode is OFF, you
cannot manually turn inverter operation ON or OFF by using the Inverter
Power button.
975-0727-01-01
Freedom Inverter/Charger Configuration
To adjust the alarm setting:
By default the alarm is set to ON ("")..
1. Press and hold the Inverter Power button for five seconds.
2. Press the Inverter Power button until the LED screen flashes
"" intermittently.
3. Press the Select button once.
The LED screen will display the present (or most recent) alarm
setting.

Sounds the alarm on all detected warning
and fault conditions
 Mutes the alarm
4. Continue pressing the Select button to cycle through the two
settings – "" and "" until you reach the desired setting.
5. Press and hold the Select button for five seconds to make the
setting permanent.
13