Programming Instructions - Panasonic KX-TD816G User Manual

2.1
Station Programming allows you, the proprietary telephone (PT) user, to program certain
features from your telephone individually. To program, you need to switch your telephone to
the Station Programming mode. And during the programming mode, your telephone is put in
a busy condition to outside caller. If you want to make a normal call handling operation, you
should finish the programming mode.
Programming Mode Display
When you enter the Station Programming mode, the display shows the following message as
the initial programming mode;
PT-PGM Mode
And the display gives you the helpful or stored data information relating to your
programming steps. In this section, we note the display example at the programming steps if
required. You can also refer to "Display Examples" in the Appendix (Section 8).
To enter the Station Programming mode
1
PROGRAM
2
9
To exit the Station Programming mode
1
PROGRAM
or
2-2
Station Programming

Programming Instructions

Be sure the telephone is idle and on-hook.
1. Press the PROGRAM button.
9
2. Dial 99.
• If 99 is not dialed within 5 seconds of pressing the PROGRAM
button, the Station Programming mode is cancelled.
• The display shows:
• The STORE indicator light turns on.
• If there is no operational entry for 1 minute, the Station
Programming mode is cancelled. Normal call handling resumes.
When the display shows the initial programming mode;
1. Press the PROGRAM button or lift the handset.
• Programming is completed and normal call handling resumes.
• If you go off-hook while programming, the mode is cancelled and
normal call handling resumes.
PT-PGM Mode
(— initial programming display)