Pe Sensor Removal - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000

4.2.5.17 PE Sensor Removal

1. Remove "Paper Guide Upper Unit". (Refer to section 4.2.5.12)
2. Remove "Tension Spring,1.2", which is installed between "Lever,
Release" and "Frame, Main, Rear".
3. Remove 2 CBP screws(3x8) securing "Lever, Assembly, Release, Cam"
to "Paper Guide Upper Unit".
4. Remove 2 "Bush, Release, Cam" from both left and right sides, and
remove "Lever, Assembly, Release, Cam". (Refer to Figure4-61)
5. Pick up 2 hooks securing "PE Sensor" to the frame, and remove "PE
Sensor". (Refer to Figure4-62)
Rev. A
"Frame, Main, Rear"
"Tension Spring,1.2"
"Lever Assembly,
Release, Cam"
"Bush, Release, Cam"
Figure 4-61. "Tension Spring,1.2", and "Lever Assembly, Release,
Cam" Removal
Hooks
PE Sensor
Figure 4-62. PE Sensor Removal
Chapter4 Assembly and Disassembly
"Lever, Release"
CBP(3x8)
4-33