Motor Assembly, Asf Removal - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000

4.2.5.9 Motor Assembly, ASF Removal

1. Remove PS unit. (Refer to section 4.2.5.6)
2. Remove a harness of "Motor Assembly, ASF" from the connector(CN16,
white) of "MB Front Unit", and remove it from locking wire saddles located
at 3 locations(around PS unit was installed) on the "Frame, Main, PF".
3. Remove a harness of "Motor Assembly, ASF" from lead cramp on the
"Paper Guide, Upper".
4. Remove one CBS screw(3x6) securing pump unit and "Frame Assembly,
DE, Left". (Refer to Figure4-30)
5. Remove 2 CBS screws(3x6) securing "Mounting board assembly, Cap"
and "Frame Assembly, DE, Left", and remove "Mounting board assembly,
Cap". (Refer to Figure4-30)
6. Remove 3 "Axis, damper, CR"s securing "Motor Assembly, ASF" to
"Frame Assembly, Pump, " by inserting the driver to notched part on the
mechanism frame, and remove "Motor Assembly, ASF" with "Mounting
board, Motor, ASF" from the frame rear side. (Refer to Figure4-31)
CAUTION
Washers are attached to each "Axis, damper, CR".
Be careful not to lose them.
Rev. A
Chapter4 Assembly and Disassembly
3 CBS screws(3x6)
"Mounting Board Assembly, Cap"
Figure 4-30. Mounting Board Assembly, Cap Removal
"Motor Assembly, ASF"
"Frame, Assembly, DE, Left"
Figure 4-31. Motor Assembly, ASF Removal
"Frame Assembly,
DE, Left"
"Axis, damper, ASF"
4-18