Epson Stylus Pro 5000 Service Manual page 161

Stylus Pro5000
Step23. Turn the printer on again.
Step24. Press Return key on the current screen, and check the
adjusted head angle from the printed pattern. Refer to figure
5-20 and repeat Step12 through Step24, until the printer
pattern becomes just like the O.K sample shown in the
figure5-20.
Step25. After adjustment is completed, leave the loosened screws as
they are loosened for next head height adjustment.
T T
WARNING
Make sure to perform Head Height Adjustment,
after the head angular adjustment is completed.
T T
Even if only the left head is replaced and the
head angular adjustment is performed only for
the left head, since head height adjustment is to
change the right head(for right colors) position
based on the left head (for dark colors) position,
loosen the screw in advance, which is fixing the
right head.
Rev. A
Chapter5 Adjustment
5-17