Maintenance - Epson Stylus Pro 5000 Service Manual

EPSON Stylus Pro 5000
Table 1-19. Download/Maintenance Mode(Cont.)
Name of Switch
After inputting Note)After entering maintenance mode level1, it
modes written in becomes EEPROM reset function by pressing
the previous page, Cleaning switch, then, Reset switch.
press Cleaning, 1.Make sure that black ink LED is on. If it is not
then, Reset switch. on, press Reset switch until the black ink LED
(Level 2) turns on.
2.After black ink LED turns on, press Eject switch
and confirm the reset.
3.To end this operation, turn the power off.
INITIALIZATION
Stylus Pro 5000 has following 3 initializations.
Y
Power on (Hardware) initialization:
This printer is initialized when turning the printer power on, or printer
recognized the cold-reset command (remote RS command). When
printer is initialized, following action is performed.
1. Initializes printer mechanism
2. Clears input data buffer
3. Clears print buffer
4. Resets default values
Y
Software initialization
The ESC@ command also initializes the printer. When printer is
initialized, following action is performed.
1. Clears print buffer
2. Resets default values
Rev.A
Function
Y
Operator(Panel) initialization
This printer is initialized when pushing the panel reset switch, or
printer recognized the /INT signal(negative pulse) of parallel
interface. When printer is initialized, following action is performed.
1. Caps the print head
2. Ejects a paper
3. Clears input data buffer
4. Clears print buffer
5. Resets default values
SETTING VALUES BY INITIALIZATION
By performing initialization, the following items return to the initial values.
Also, the panel setting, default setting, and item that can be saved on the
remote command will be default values.
1. Page position:
2. Line spacing:
3. Right margin position:
4. Left margin position:
5. Word pitch:
6. Printing mode:
Chapter1 Product Description
Page heading location as present
paper location
1/6 inch
127 lines
First line
10 CPI
Text mode(Not raster graphics mode)
1-14