Power Supply - Epson Stylus Pro 5000 Service Manual

4
T
O REMOVE THE POWER SUPPLY
4-28
Service Procedures

Power supply

The fan-cooled 60 watt power supply in the RIP Station 5000 has an input range of
100V AC to 240 V AC.
Inside the chassis the power supply is not encased. Before you service the
N :
OTE
RIP Station 5000, shut it down completely (at Idle, power it off ) and unplug the AC
power cable from the back.
Power supply on the center frame
F 4-20
IGURE
1. Shut down the RIP Station 5000
(see "To shut down the RIP Station 5000" on page 4-2).
2. Open the RIP Station 5000
(see "To open the RIP Station 5000" on page 4-3).
3. Remove the front panel
(see "To remove the front panel" on page 4-6).
4. Remove the two screws that attach the bottom EMI shield.
Set aside the bottom EMI shield and the screws for reassembly.
Chassis ground pin
Power switch
Center frame
AC power cable
Ground cables
Power supply
Cable to motherboard
Cable to HDD