Checking The Internal Components - Epson Stylus Pro 5000 Service Manual

5
Preliminary on-site checkout
Power switch
Power connector
Only one Ethernet connection can be made at a time.
N :
OTE
Back panel of RIP Station 5000 showing connectors
F 5-2
IGURE
If all the connectors are properly in place and the power is on, proceed to the next stage
of troubleshooting.

Checking the internal components

To check the internal components you must open the RIP Station 5000.
Before you open the RIP Station 5000, be aware of the safety precautions you should
take when handling the RIP Station 5000, and use ESD precautions when handling
printed circuit boards and electronic components. To review the safety precautions, see
"Precautions" on page x.
Use the guidelines in Chapter 4 when disassembling, checking, and reassembling the
RIP Station 5000.
SCSI interface connector
Not used
Parallel port connector
Printer interface connector
AUI connector for thinnet or thicknet
10/100BaseT for twisted pair Ethernet
Serial port (not used)
5-5