Tools You Will Need - Epson Stylus Pro 5000 Service Manual

xii
Preface
• Leave new electronic components inside their antistatic bags until you are ready to
install them. When you remove components from an antistatic bag, place them on a
grounded antistatic surface, component-side up.
• When you remove an electronic component, place it into an antistatic bag
immediately. Do not walk across a carpet or vinyl floor while carrying an unprotected
board.
8. Handle printed circuit boards by their edges only, but avoid touching the contacts on the
edge of the board.
9. Never set a cup of coffee—or any liquid—on or near the RIP Station 5000 or the printer.

Tools you will need

To install or service the RIP Station 5000, you should bring the following tools:
• ESD wrist grounding strap
• Wire cutters
• #0 and #1 Phillips head screwdrivers (non-magnetic)
• Small flat-blade screwdriver (non-magnetic)
• Small needlenose pliers
• M3 metric wrench
• Flashlight
Also recommended are:
• Ribbon cable connector extractor
• Air brush
You should also bring this guide and any Technical Support notes you may have for the
RIP Station 5000.