Toyota 4runner 2010 Instruction Manual page 53

1-2. Opening, closing and locking the doors
Setting and canceling the functions
■
To switch between setting and canceling, follow the procedure
below:
Vehicles without a smart key system
STEP 1
Close all the doors and turn the engine switch to the "ON"
position. (Perform step 2 within 20 seconds.)
Vehicles with a smart key system
Close all the doors and turn the "ENGINE START STOP"
switch to IGNITION ON mode. (Perform step 2 within 20 sec-
onds.)
STEP 2
Function
Shift position linked door lock-
ing function
Shift position linked door
unlocking function
Speed linked door locking func-
tion
Driver's door linked door unlock-
ing function
54
Shift the shift lever to P or N, and
press and hold the driver's door
lock
approximately 5 seconds and
then release.
The shift lever and switch posi-
tions
desired function to be set are
CTH12AS016
shown in the following table.
Use the same procedure to can-
cel the function.
Shift lever
position
P
N
or
switch (
corresponding
Driver's door lock
switch position
) for
to the