Motorola RFS6000 Reference Manual page 79

• enhanced-probe-table [enable|erase-report|max-mu|
preferred|window-time] – Enhanced probe table for MU
locationing.
• enable – Enables the Enhanced Probe Table feature for
MU locationing.
• erase-report – Erases the reports for Enhanced Probe
Table feature.
• max-mu <0-512> – Sets the maximum MUs in the
Enhance Probe Table report.
• preferred <MAC> – Add the MAC <MAC> to the
preferred MU list.
• window-time – Sets the Window Time for probe
collection in seconds to a value in the range 10 to 60
seconds.
• free-packet-watermark – It is free packets threshold. If
the percentage of free packets is lower than this number,
then additional packets will not be queued up in the
datapath
• idle-radio-send-multicast – Forward multicast packets to
radios without associated mobile units
• legacy-load-balance – Invoke legacy load balance
algorithm
• map-radios – Set radio-to-cpu mapping constant
• radio-misc-cfg – radio specific misc configuration U16 for
all radios
• rate-scale – Enable wireless rate scaling (default)
• request-ap-log – Request ap Log
• save-ap-log – Saves debug/error logs sent by the
access-port
• snmp-trap-throttle – Limits the number of SNMP traps
generated from the wireless module
• sync-radio-entries – sync radio configuration at cluster
levels
• vlan-cache – VLAN-cache mode
Common Commands 2-31