Motorola RFS6000 Reference Manual page 953

scan-dwell-time <1-10>
schedule-calibrate
[enable|interval|
start-time]
service smart-rf
[max-history|replay
(enable)|rescue]
select-channels <WORD> Revert selected- channels to default
smart-rf-module enable
verbose enable
Example
RFSwitch(config-wireless-smart-rf)#no ?
assignable-power-range
auto-assign
beauto-assigned
extensive-scan
everytx-power level
hold-time
detection.
number-of-rescuers
rescuers to cover faulty radio
radio
recover
features
Resets the time a scan dwells on a channel during scan
Resets the calibration schedule parameters
• enable – Disables the calibration schedule feature
• interval – Negates the calibration schedule interval
• start-time – Negates the calibration schedule start time
Resets the Smart RF related service commands
• smart-rf max-history – Resets the maximum number
history entries
• replay enable – Disables the replay mode
• rescue <WORD> – Removes rescue operation
• WORD – A single radio MAC address
• WORD– A comma-separated list of channels
Disables the feature
Disables the verbose mode of recording every assignment
reset the power range to default
disable individual RF parameters to
extensive scan mode, calibrate at
The number of seconds to disable
interference avoidance after a
This prevents a radio from changing
channels continuously
revert to default the number of
Radio related commands
disable individual self-recovery
Smart RF Instance 25-15