Toshiba GD-1190 Service Manual page 23

Main Sub
Contents
code code
66 32 Receive data check
33 Signal detection check
34 Communication time
measurement
37 Speaker sound volume
setting
[Function]
Use to check the receive data.
[Operation]
1) Initial display
RECEIVING
[Function]
Use to check the signal detection.
[Operation]
1) Initial display
CHECKING NONE
PRESS CLEAR TO STOP
When a signal is detected, the display is changed from NONE to the following.
CI/CNG/CED/BT/DT/Flag/SDT/DTMF
∗
[CLEAR] key: Returns to the main-sub code input display.
[Function]
Use to measurement the communication time.
[Operation]
1) Initial display
COMM. TIME
xx:xx:xx:xxx msec
"xx:xx:xx:xxx" indicates o'clock, minute, second, millisecond.
∗
[CLEAR] key: Returns to the main-sub code input display.
[Function]
Use to set the speaker sound volume.
1: NO SOUND
2: LOW
3: MID
4: HIGH
[Operation]
1) Initial display
SELECT SPEEKER VOL.
PRESS ←, →
2) [←/→] or after 2sec
Every time when [→] key is pressed, the second line is changed in the sequence of 1 → 2 → 3 →
4 → 1.
When [←] key is pressed, the sequence is reversed.
SELECT (1-4)
1:NO SOUND
∗
[CLEAR] key: Returns to the main-sub code input display.
3) [ENTER] key
STORED
xxx
xxx: Set content
After 2sec, main code and sub code input display.
GD-1190 TEST COMMAND 3 - 10
Details of function/operation
2) After completion of reception
RESULT
"xx" is "OK" or "NG" depending on the check
result.
∗
[CLEAR] key: Returns to the main-sub code
input display.
SELECT (1-4)
2:LOW
xx
.....