Main
Sub
Contents
code
code
66
18
DTMF signal send (Soft SW
set value)
21
FAX information print
24
FAST SRAM clear
30
TEL/LIU status change
check
[Function]
Use to set the DTMF signal send (Soft SW set value).
[Operation]
1) Initial display
INPUT DIAL #
∗
[CLEAR] key: Returns to the main-sub code
input display.
2) [10KEY] input
The content selected with signal send level
selection is set inside.
[Function]
Use to print the FAX information.
[Operation]
1) Initial display
SELECT REPORT (1-3)
PRESS ←, →
2) [←/→] or after 2sec
Every time when [→] key is pressed, the second line is changed in the sequence of 1 → 2 → 3 →
1.
When [←] key is pressed, the sequence is reversed.
SELECT REPORT (1-3)
1:USER SW. LIST
∗
[CLEAR] key: Returns to the main-sub code input display.
3) [ENTER] key
• When print is allowed
PRINT STORED
After completion of printing,
main code and sub code input
display.
[Function]
Use to clear the FAST SRAM.
[Operation]
1) Initial display
CLEAR FAST SRAM
[Function]
Use to check the TEL/LIU status change.
[Operation]
1) Initial display
HS2 :xxx
HS1 :xxx
RHS :xxx
EXHS:xxx
↑
The display is switched every 2sec.
↓
CHECKING
PRESS CLEAR TO STOP
∗
[CLEAR] key: Returns to the main-sub code input display.
GD-1190 TEST COMMAND 3 - 9
Details of function/operation
3) Communication is started after setting the
signal send level.
SENDING SIGNAL SSW
PRESS CLEAR TO STOP
∗
[CLEAR] key: Returns to "1) Initial display".
SELECT REPORT (1-3)
2:SOFT SW. LIST
• When print is inhibited
CAN NOT PRINT
After 2sec, FAX control is
terminated.
2) After completion of clearing
CLEARED
After 2sec, main code and sub code input dis-
play.
SELECT REPORT (1-3)
3:PROTOCOL