Toshiba GD-1190 Service Manual page 17

Main Sub
Contents
code code
46 39 FAX mode sharpness
adjustment
66 01 FAX soft SW setting
02 FAX soft SW initializing
(excluding the adjustment
values)
[Function]
When [START] key is pressed, scan is started with the entered sharpness adjustment value, and the
data of the selected mode stored on the FAX side is changed to the entered value.
Sharpness adjustment value data table
Mode Sharpness adjustment value
1: STD
2: FINE
3: S-FINE
4: FINE/PHOTO
5: S-FINE/PHOTO
When initializing each data: 1
[Operation]
1) Initial display
SHARPNESS SETTING
← →
PRESS ,
2) [←/→] or after 2sec
Every time when [→] key is pressed, the
second line is changed in the sequence of
No. 1 → 2 → 3 → 4 → 5 → 1.
When [←] key is pressed, the sequence is
reversed.
SHARPNESS SET (1-5)
1:STD
3) Select the arrow key 1-5, and the LED of
[START] key is lighted.
SHARPNESS SETTING
ZZZZ(0-2) X
("ZZZZ" is the mode selected among STD,
FINE, S-FINE, FINE/PHOTO, and S-FINE/
PHOTO.)
("X" is the corresponding sharpness adjustment
value of the selected mode stored on the FAX
side.)
∗
[CLEAR] key: Returns to "2)" display.
[Function]
Use to check the FAX soft SW setting.
Every time when the key is pressed, the bit on the first line is switched 0 and 1.
[Operation]
1) Initial display
ENTER FAX SOFT SW. #
(3 DIGITS) SW.___
∗
[CLEAR] key: Returns to the main-sub code
input display.
2) Enter a 3-digit value of soft SW No. (To
enter the fourth digit, shift to the left.), and
the press [ENTER] key.
No.### xxxxxxxx
CHANGE? 1:YES 2:NO
"xxxxxxxx" is the set content.
∗
Select 2: Returns to the soft SW No. entry dis-
play.
[Function]
Use to initializing FAX soft SW.
[Operation]
1) Initial display
INITIALIZED
After 2sec, main code and sub code input display.
GD-1190 TEST COMMAND 3 - 4
Details of function/operation
4) Enter a one-digit value (0-2) as the sharp-
ness adjustment value with [10KEY].
SHARPNESS SETTING
ZZZZ(0-2)
("Y" is the entered sharpness adjustment value.)
∗
[CLEAR] key: Returns to "2)" display.
5) Scan start (self print)
SHARPNESS SETTING
SCAN
6) Print start (self print)
SHARPNESS SETTING
PRINT
After completion of printing, returns to "4)"
display.
3) Select 1
No.###
USE # KEY
4) Change with 1-8 of [10KEY] and the press
[ENTER] key.
No.###
STORED?
"xxxxxxxx" is the set content.
∗
Select 2: Returns to the soft SW No. entry dis-
play.
5) Select 1
STORED
After 2sec, returns to "1) Initial display".
Y
Y
Y
xxxxxxxx
12345678
xxxxxxxx
1:YES 2:NO