Toshiba GD-1190 Service Manual page 19

Main Sub
Contents
code code
66 05 Signal send mode (Soft SW
set value)
07 Image memory content print
10 Image memory content clear
[Function]
Use to set the signal send mode (Soft SW set value).
Facsimile test command design specifications.
1 NO SIGNAL
2 33600bps(V34)
3 31200bps(V34)
4 28800bps(V34)
5 26400bps(V34)
6 24000bps(V34)
7 21600bps(V34)
8 19200bps(V34)
9 16800bps(V34)
10 14400bps(V34)
11 12000bps(V34)
12 9600bps(V34)
[Operation]
1) Initial display
SELECT OUTPUT SIGNAL
(2 DIGITS) No.___
2) 2-digit (1-35) with [10KEY] / [←/→] / 2sec after
Pressing [→] key or [←] key reverses the sequence.
No. (1-35)
1:NO SIGNAL
∗
[CLEAR] key: Returns to the main-sub code input display.
3) [ENTER] key
Send after setting
OUTPUTING SIGNAL SSW
PRESS CLEAR TO STOP
∗
[CLEAR] key: Returns to "1) Initial display".
[Function]
Use to print the image memory content.
[Operation]
• When print is allowed
PRINT STORED
After completion of printing,
main code and sub code input
display.
[Function]
Use to clear the image memory content.
[Operation]
• When there are some print data
CLEAR IMAGE MEMORY
After completion of memory clear, the buzzer
sounds.
CLEARED
PLEASE POWER OFF
Remains unchanged until the power is turned
off.
GD-1190 TEST COMMAND 3 - 6
Details of function/operation
13 7200bps(V34)
14 4800bps(V34)
15 2400bps(V34)
16 14400bps(V33)
17 12000bps(V33)
18 14400bps(V17)
19 12000bps(V17)
20 9600bps(V17)
21 7200bps(V17)
22 9600bps(V29)
23 7200bps(V29)
24 4800bps(V27ter)
..... No. (1-35)
35:LINE ON HOOK
• When there is no print data
NO DATA
After 2 sec, FAX control is
terminated.
• When there are no print data
CLEAR IMAGE MEMORY
After completion of memory clear
CLEARED
After 2sec, main code and sub code input dis-
play.
25 2400bps(V27ter)
26 300bps(FLAG)
27 2100Hz(CED)
28 1100Hz(CNG)
29 300bps(V21)
30 2100Hz(ANSam)
31 DUMMY RING
32 NO VOICE ANSWER
33 NO RING BACK TONE
34 LINE OFF HOOK
35 LINE ON HOOK
• When print is inhibited
CAN NOT PRINT
After 2 sec, main code and sub
code input display.