Toshiba GD-1190 Service Manual page 14

[3] TEST COMMAND
1. Entering the test command mode
To enter the serviceman test command mode, press the keys as
follows:
→ → →
[#] key [*] key [C] key [*] key
To cancel the test command mode, press the [CA] key.
2. Key rule
[10KEY]: Entry of MAIN CODE/SUB CODE
Selection of an item
Setup of an adjustment value in case of test commands for adjustment
← →
[ / ]: Selection of MAIN CODE/SUB CODE
Selection of an item
[ENTER/START]: Settlement
<In case of test commands for print>
[ENTER]:
[START]:
[C]: (Interrupting operation check) Returns to the upper hierarchy.
In case of test command of operation check, terminates the operations.
[CA]: Exits from the test command mode.
For a test command of adjustment, the display returns to the initial display (00-00).
3. List of test commands
Main Sub
code code
22 11 FAX-related counter display
24 10 FAX counter clear (FAX CLR.)
46 12 Density adjustment in the FAX mode (Collective
adjustment)
13 FAX mode density adjustment (normal text)
14 FAX mode density adjustment (Fine text)
15 FAX mode density adjustment (Super fine)
39 FAX mode sharpness adjustment
66 01 FAX soft SW setting
02 FAX soft SW initializing (excluding the adjustment
values)
03 FAX PWB memory check
04 Signal send mode (Max. value)
05 Signal send mode (Soft SW set value)
07 Image memory content print
10 Image memory content clear
11 300bps signal send (Max. value)
Settlement (Without print)
Settlement/Print
Contents
GD-1190 TEST COMMAND 3 - 1
Main Sub
code code
66 12 300bps signal send (Soft SW set value)
13 Dial test
17 DTMF signal send (Max. value)
18 DTMF signal send (Soft SW set value)
21 FAX information print
24 FAST SRAM clear
30 TEL/LIU status change check
32 Receive data check
33 Signal detection check
34 Communication time measurement
37 Speaker sound volume setting
38 Time setting/check
41 CI signal check
Contents