Lowering The Murphy Bed - Jayco 2016 White Hawk Owner's Manual

JAYCO TOWABLE

Lowering the Murphy bed:

Unlatch the "D" bolt latches on each side of the bed at the footboard (in the stored

position). This will release the Murphy bed allowing it to unfold.

Firmly grasp the handle on the footboard of the Murphy bed, and pull it towards you.
The bed will begin to unfold. Pull it all the way down so the footboard rests on the
floor.

When the bed is in the sleeping position, locate the web straps with snap hooks on the
footboard of the bed (there is one on each side of the bed). Attach (both) snap hooks
to the metal loops located on the sofa arms. These straps and loops keep the bed
from folding up while in use.
Snap hooks must be attached to the steel rings on the sofa arms before using the
bed. Failure to attach these snap hooks to the steel loops on the sofa can result in
serious injury or property damage.
NOTE: The straps are adjustable. They have been installed at a length that holds the
bed securely in place and allows ease of attaching the snap to the metal loops.
This label is located below next to the
slide out controls inside the entrance
door.
It should not be removed.
Remove the straps holding the mattress to the bed frame by unsnapping the two plastic
buckles on top of the mattress. These straps can be stored on the side of the mattress, or
tucked between the headboard and the mattress. Release the mattress hook from the foot
of the bed.
MAKE SURE THE SAFETY STRAPS AT EACH SIDE OF THE FOOTBOARD
ARE ATTACHED TO THE STEEL LOOPS ON THE SOFA ARMS BEFORE
PUTTING ANY WEIGHT ON THE BED.
"D" Bolt
WARNING
12-7
SECTION 12 - INTERIOR
CAUTION
The two straps on both sides of the Murphy
bed must be secured to the D-rings on
each side of the sofa anytime the bed is in
the down position to prevent inadvertent
lifting.
The bed can lift or fold up unexpectedly
which could result in personal injury.
Safety
Strap &
Loop