Campsite Hook-Up; Leveling The Rv; Stabilizer Jacks; Manual Stabilizer Jacks - Jayco 2016 White Hawk Owner's Manual

JAYCO TOWABLE
C H
AMPSITE OOK

Refer to Electrical System section before connecting the shore line power cord (when
using full hook-up) OR before starting the generator (if so equipped) or operating the
vehicle on 12-volt power when dry camping.

Refer to Fuel & LP System section before using the LP system. Open the LP gas tank
valve (if so equipped) slowly. There may be air in the lines and five to thirty seconds
of time is needed to bleed air before LP vapor fills the lines.

Refer to Plumbing Systems section before connecting the fresh water supply or
turning ON the water pump or water heater.

When using full hook-up, connect the sewer hose to the campsite sewer hook-up.

If applicable, start the refrigerator and the cooling or heating system.
NOTE: For extended dry camping, management of all your resources is essential.
Check your battery levels and conserve battery power, use it sparingly
L RV
EVELING THE
Now that you have parked your recreation vehicle, you need to ensure it is level. Leveling
is very important. A level vehicle is more comfortable for sleeping and walking.
The refrigerator is designed to operate when level for best performance due to the
absorption system. The water drainage systems are designed with proper slope and must be
level for proper operation. The appliances perform best when level.
S J
TABILIZER ACKS
1. Each stabilizer jack can be individually adjusted to stabilize the trailer for use.
2. When setting your RV up on soft ground, you may wish to place a wood pad or
the equivalent under each stabilizer jack foot. This will help keep the stabilizer
jack from sinking into the ground.
Manual stabilizer jacks (if so equipped)
To lower each jack, insert the jack crank onto the applicable stabilizer jack shaft.
1. To lower each jack, insert the jack crank onto the applicable stabilizer jack shaft.
2. Turn the crank clockwise to lower each leg until it contacts the ground and stabilizes
the trailer.
To raise each jack, insert the jack crank onto the applicable stabilizer jack shaft and turn
the crank counter-clockwise.
Electric stabilizer jacks (if so equipped)
Control switches for the stabilizer jacks are located on the (door) side of the unit above the
stabilizer jack(s).
To lower each jack, press the control switch until each leg contacts the ground and
stabilizes the unit.
To raise the jack, press the control switch until the jack is returned to the retracted position.
 NOTE: The stabilizer jacks must be fully retracted before moving or towing the
RV to prevent stabilizer jack damage.
DO NOT USE THE STABILIZER JACKS TO LEVEL THE RV. It is important
to remember that the stabilizer jacks are to be used only for support while occupying
and moving around the RV. They are not designed to support the weight of the RV.
-U
P
SECTION 4 – VEHICLE OPERATION
WARNING
4-5 WHTT