Table of Contents
Advertisement
The slide out must be fully extended before putting the Murphy bed in the
sleeping position. The Murphy bed must be in the stored position before the
slide out can be moved to the in (travel) position. Failure to do so may result
in injury or property damage
This label has been installed in your recreation-
al vehicle at the foot end of the Murphy bed. It
should not be removed.
Unfolding the Sofa
With the slideout fully extended, unfold the sofa
into the flat position.
Standing at the side of the sofa, grasp
the front of the seat cushion and the top
of the back cushion (A) (arrows).
Lift up on the seat cushion while pulling
the top of the back cushion in toward the
seat. The seat and back will form a "V" shape. (B).
Pull the seat cushion out away from the front of the sofa into the flat position (C).
Lowering the Murphy Bed
Unlatch the "D" bolt latches on each side of the bed at
the footboard (in the stored position). This will release
the Murphy bed allowing it to unfold.
Firmly grasp the handle on the footboard of the Murphy
bed, and pull it towards you.
The bed will begin to unfold. Pull it all the way down so
the footboard rests on the floor.
When the bed is in the sleeping position, locate the web
straps with snap hooks on the footboard of the bed (there
is one on each side of the bed). Attach (both) snap hooks
to the metal loops located on the sofa arms. These straps
and loops keep the bed from folding up while in use.
NOTE: The straps are adjustable. They have been installed at a
length that holds the bed securely in place and allows ease of attach-
ing the snap to the metal loops.
Section 12: Interior
155
Advertisement
Table of Contents
