Retracting Slideout Room; Troubleshooting The Slideout; Slideout System – Schwintek Inwall - Jayco 2016 White Hawk Owner's Manual

SECTION 5 – SLIDE-OUT SYSTEMS
After the slideout is extended, verify that the corners of
the black rubber seal are set up correctly. The corners of
this seal are cut at a 45° angle. The top of the outside seal
must overlap the side of the seal to avoid the possibility
of water penetration. On the inside seal, the side seal
should overlap the top.

Retracting slideout room

Press the IN section of the slideout control switch and hold it until the motor stops.
Operating the switch after the room is fully retracted will damage the switch and motor.
Maintenance
Do not work on your system unless the 12-volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical systems (shore line power cord) have been
disconnected.
Your slideout system has been designed to require very little maintenance. To ensure a
long life of your slideout system, read, understand and follow these simple instructions.
This system contains a pre-lubed bearing that is lubricated when the room is moved in and
out. Do not spray oil or grease on the rails while the room is extended.

Troubleshooting the Slideout

If the slideout does not move when the slideout switch is depressed, follow these steps.

Check the auxiliary battery (customer supplied) for a full charge and good wire
connections.

Check the 12-volt fuse or circuit breaker.

Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps.

If the slideout is extended, refer to the section on operating the specific slideout
system installed on your RV.

If the slideout is retracted, leave it in that position.

Contact your dealer or customer service for repair assistance.
Your recreation vehicle may include one or more of the following slideout systems.
Schwintek Inwall slideout system
The in-wall slideout system requires no maintenance it will never require any adjustments.
The in-wall system has two vertical columns. Each side has a drive motor located at the
top of the column. The right hand and left hand motors remain synchronized by the dual
motor synchronous velocity slide controller (a circuit board typically located in the
basement area of the recreation vehicle.
Additional support jacks are not needed under the slideout. Damage can occur to your
slideout room from improper use of aftermarket support jacks.
WARNING
CAUTION
5-2
JAYCO TOWABLE
Slideout overlap-outside