Table of Contents
Advertisement
Section 12: Interior
Solid surface sink maintenance
Occasionally, clean the solid surface sink by filling one-quarter full with a 50/50 water/
bleach solution. Let soak for 15 minutes, and then wash sides and bottom of sink as solution
drains. Run cold water when pouring hot/boiling water into the sink.
Flooring
Always test a cleaning agent in an inconspicuous area for colorfastness.
Carpet
Vacuum your carpet regularly. It is important to remove loose soil and debris while it is on
the surface. Heavily traveled areas (i.e., walkways, areas in front of the furniture) may be
protected with small throw rugs to prolong the life of the carpet.
Prompt attention to spots and spills is essential. Remove as much of the spill as possible.
Absorb wet spills as quickly as possible by blotting repeatedly with white paper or cloth
towels.
Refer to the manufacturer's guide for detailed cleaning information, or contact a cleaning
professional.
Vinyl Flooring
Periodically vacuum or sweep to remove dirt and gritty particles. Although most common
spills will not permanently stain the vinyl floors, they are usually easier to remove if wiped
up before they set. Blot with a paper towel and wipe clean with a damp cloth. Do not use
dish detergents or vinegar and water because they will dull your floor.
To care for the vinyl floor covering, use a damp mop with water and a mild cleaner on the
entire floor. DO NOT SOAK THE FLOORING. Use care to avoid wetting the carpet edges.
To avoid problems of "yellowing" linoleum, the flooring manufacturer recommends avoid-
ing cleaners that contain oil based solvents (i.e. lemon oil, Murphy's Oil Soap, etc.).
Murphy Bed (if so equipped)
Your recreational vehicle may be equipped with a folding Murphy bed. When in the closed
position, the bed is stored in the wall allowing for more living space within the vehicle.
When you want to use the bed, the sofa folds flat and the bed can be pulled down over the
sofa into the sleeping position.
Stored Position
The slide out must be fully extended before putting the Murphy bed in the
sleeping position. The Murphy bed must be in the stored position before the
slide out can be moved to the in (travel) position. Failure to do so may result
in injury or property damage
154
Maintenance Record
Sleeping Postion
Table of Contents
Advertisement
Table of Contents
