Flush Floor Slideout; Trouble Shooting The Flush Floor Slideout - Jayco 2016 White Hawk Owner's Manual

SECTION 5 – SLIDE-OUT SYSTEMS
10. Physically push or pull the room back into the opening, keep both sides relatively
even.
11. The room must be travel locked to keep the room in place for road travel.
DO NOT MOVE THE RV UNLESS THE MOTORS ARE PLUGGED IN TO
THE CONTROLLER AND THERE IS BATTERY POWER TO THE RV.
THIS SETS THE BRAKES ON THE SLIDEOUTS TO PREVENT THEM
FROM MOVING DURING TRANSIT.
Error Codes
When an error code occurs during operation, the board will use the LEDs lights to indicate
where the problem is. For motor specific faults the green LED will blink (1) time for motor
#1 and (2) times for motor #2. The red LED will blink from 2 to 9 times depending on the
error code. Error codes are as follows:
2 times Battery drop out: battery capacity low enough to drop below 6 volts while
running.
3 times Low battery: voltage is below 8 volts at the start of a cycle.
4 times High battery: voltage is greater than 18 volts.
5 times Excessive motor current: high amperage, also indicated by (1) side of the
slide continually stalling.
6 times Motor short circuit: motor or wiring to motor has shorted out.
8 times Hall signal not present: encoder is not providing a signal; usually a wiring
problem.
9 times Hall power short to ground: power to encoder has been shorted to ground;
usually a wiring problem.
When an error code is present, the board needs to be reset. Energizing the extend / retract
switch will reset the board. Energize the extend / retract switch again to go back to normal
operation.
Refer to the Schwintek Slide Room Operation Guide for further information. Call Lippert
at (866) 524 – 7821 or visit the Lippert website at www.lci1.com for additional
troubleshooting information.

Flush Floor Slideout

For optimum performance, the slide-out system requires full battery current and voltage.
Although the system is designed to be almost maintenance free, actuate the room once or
twice a month to keep the seals and internal moving parts lubricated. Check for any visible
signs of external damage after and before movement of the travel trailer.
NOTE: For long-term storage it is recommend the room be closed (retracted).

Trouble shooting the flush floor slideout

If the slideout does not move when the slideout switch is depressed, follow these steps.

Check the auxiliary battery (customer supplied) for a full charge and good wire
connections.

Check the 12-volt fuse or circuit breaker.

Check for loose connections at the slideout motor.

If the slideout still will not operate, follow these steps.

If the slideout is extended, refer to the following section on overriding the specific
slideout system installed on your RV.

If the slideout is retracted, leave it in that position.

Contact your dealer or customer service for repair assistance.
WARNING
5-6
JAYCO TOWABLE