Manually Pushing In The Slideout; Disengage Motors, Manually Retract The Room And Travel Lock - Jayco 2016 White Hawk Owner's Manual

JAYCO TOWABLE
Slideout System
Controller
During this override procedure the motors are not synchronized. Visually watch the
room, and if one side is moving significantly slower than the other (or not at all),
immediately stop and call your dealer or Customer Service.
If the system stalls our before reaching end of stroke OR if the room does not close
and seal tightly, call your dealer Customer Service.

Manually pushing in the slideout

1. Locate the slideout system controller
2. Unplug motor 1 and motor 2 connectors at the bottom of the slideout controller. This
releases the motor brakes for each motor.
3. The slideout room can now be manually pushed in. Larger rooms may require several
people to push or pull them.
4. Keep both sides of the slideout relatively even while pushing/pulling.
5. When the room is completely in, plug both motor connectors back into the control
module. This will apply the motor brakes for road travel.

Disengage motors, manually retract the room and travel lock

6. Locate and remove the motor retention screw which can be found near the top of each
vertical column (Fig. 3).
7. Bend back the wipe seal and visually locate the motor (Fig. 4).
8. Pull the motor up until it disengages (about 1/2 inch).
9. Repeat this process for both sides of the slide room.
SECTION 5 – SLIDE-OUT SYSTEMS
MOTOR 2
MOTOR 1
CAUTION
CAUTION
5-5