Electric Slide Room System (If So Equipped) - Jayco 2016 White Hawk Owner's Manual

JAYCO TOWABLE

Electric Slide Room System (If So Equipped)

Make sure the interior slideout room path and the slideout room itself is clear of
people and objects before operating. Keep away from the slide rails and gear
assembly when the room is in motion. They may pinch or catch on loose clothing
causing personal injury. Failure to follow these instructions could result in serious
injury or death.
Make sure the vehicle is level before operating the slideout room. Water leaks and
other problems could result if the slideout is operated without leveling the vehicle.
Do not place excessive weight in the slideout room. It can cause the slideout room to
malfunction and cause damage to the slideout.
Make sure the slideout is in the closed position prior to hooking the unit to the tow
vehicle.
The slideout room system is designed for additional floor space and comfort. The
mechanical components are gear driven. Electric powered slideout room systems have a
manual override to allow you to extend or retract the slideout room(s) in case of a power
loss. Make sure you have sufficient power available before operating your slideout system.
Additional support jacks are not needed under the slideout. Damage can occur to your
slideout room from improper use of aftermarket support jacks.

The auxiliary battery (customer supplied) must be fully charged and connected. If
possible, the RV should be hooked up to 120-volt AC power so the converter
operates.

The RV must be level and the stabilizer jacks in the extended position.

Locate the slideout control switch. To move the room out, press the OUT section of
the switch and hold it until the motor stops (travel time is approx. 25 seconds).
Operating the switch after the room is fully extended will damage the switch and
motor.
SECTION 5 – SLIDE-OUT SYSTEMS
WARNING
CAUTION
CAUTION
CAUTION
CAUTION
5-1