Toilet - Jayco 2016 White Hawk Owner's Manual

JAYCO TOWABLE
4. Attach the other end of the water hose to a pressurized water source (40 PSI
minimum).
5. Turn ON the water source flushing the tank until water appears to run clear from the
sewer hose.
6. Turn water source OFF. Disconnect water hose from the source and from the tank
flush inlet.
7. Close the black water dump valve.
The black tank drain valve must be OPEN any time there is a hose (water supply)
connected to the black tank flush.
Do not leave any hose (water supply) connected to the black tank flush when it is not
in use.
Do not use the same hose to fill your fresh (potable) water tank that is used for the
black tank flush.
T
OILET
The toilet is efficient and easy to operate. Generally, more water is required only when
flushing solids. Prior to using the sanitation system, it is strongly recommended to flush
the toilet several times to release sufficient water into the holding tank. If there is not a
sufficient amount of water used during flushing, the waste materials may not evacuate
properly from the drain line to the tank. Clogged tanks and pipes could eventually occur.
The toilet system will perform better when water is run for ten to fifteen seconds after
flushing to ensure that the waste will proceed to the bottom of the tank.
Unlike a toilet in a home, which may use up to seven gallons of water per flush, the
average recreation vehicle system uses one to three quarts (1 - 3 liters). For added
convenience and better sanitation system performance, it is advisable to always have four
to six inches (10 - 15 cm) of water in the toilet.
It is important to prevent solid waste buildup. Follow the toilet manufacturer's
recommended instructions each time after emptying the black water holding tank.
To prevent help toilet blockage, always use RV grade single-ply toilet paper. Do not
flush paper towels, diapers, sanitary napkins or other foreign objects down the toilet.
SECTION 8 – PLUMBING SYSTEM
CAUTION
CAUTION
WARNING
WARNING
CAUTION
8-19