Installing New Ink Cartridge(S) - Pitney Bowes da95f Operator's Manual

Installing New Ink Cartridge(s)

1. Remove the cartridge from the shipping
container by peeling the top cover off. Be
careful not to touch the copper ribbon.
2. Gently remove both pieces of tape
covering the ink nozzles on the cartridge.
Be careful not to touch the copper
nozzles.
3. Raise the latch all the way up on the print
head assembly if it is not already. Holding
the cartridge by it's top handle, gently
insert the cartridge down at approximately
a 45 degree angle into the cradle.
4. Push down until the cartridge
is seated on the bottom of the
print head assembly.
5. Press the blue latch down to
lock the cartridge in place.
6. Repeat this process if
necessary for the remaining
ink cartridges.
7. Next you'll need to run a print head alignment procedure for the
print head assemblies that you have installed new ink cartridges
into (A & B). See Performing a Print Head Alignment in this
chapter.
WARNING!
• Reset the ink count through the main menu>ink count after
replacing an ink cartridge. This will enable the printer to
accurately monitor ink consumption.
SV61749 Rev. D
Printer Maintenance • 3
3-3