Material Specifications - Pitney Bowes da95f Operator's Manual

Material Specifications

Media Size
The printer can print on the following range of material sizes.
Width
Minimum 5" (127 mm)
Maximum 14" (355.6 mm) 15.5" (393.7 mm)
Material Notes
Envelopes must have a flap along the long edge and are processed
by the printer non-flap edge first (see illustration).
Envelopes may have either a diagonal or straight edge along the
envelope flap. Stuffing materials must be machine folded (C, Z, or
1/2 folded) or cut sheets.
Booklets are defined as media having physical dimensions 6"
(152mm) x 9" (229mm) or larger. Booklets have an opening along
their long edge which is covered by a flap with an adhesive seal.
Catalogue envelopes have an opening along their short edge which
is closed by a flap with an adhesive seal.
Postcards have no folds or bends. The printable side may have a
higher surface roughness than the non-printable side.
Self-mailers may be of "C," "Z," or 1/2-folded construction. They may
not exceed the maximum allowable thickness as specified on the
previous page and must be tabbed per postal regulations. 1/2 and
tri-folds must be machine produced.
A catalogue may consist of multiple pages bound by adhesive or tabs
on the feed edge or at 90 degrees with respect to the feed edge.
Sheet stock may consist of 16 to 28 lb (60 to 105 g/m2) bond and
60 to 80 lb (227 to 302 g/m2) coated stock. The size and thickness
constraints specified above apply.
SV61749 Rev. D
Specifications • Appendix A
Height
3.5" (88.9 mm)
Non-flap
Lead Edge
Flap Edge
(flap faces down)
Thickness
.003" (.076 mm)
.5" (12.70 mm)
A-5